![standard access acl packet tracer activity 1 standard access acl packet tracer activity 1](https://itexamanswers.net/wp-content/uploads/2017/07/7.2.1.6-Packet-Tracer-Configuring-Numbered-Standard-IPv4-ACLs-Instructions-768x621.jpg)
A second rule must be created on R2 to permit all other traffic. The access list must be placed on the outbound interface to the WebServer. To restrict access from the 192.168.11.0/24 network to the WebServer at 192.168.20.254 without interfering with other traffic, an ACL must be created on R2.The following network policies are implemented on R2:.Step 2: Evaluate two network policies and plan ACL implementations. You should be able to successfully ping every device.
#Standard access acl packet tracer activity 1 full#
Verify that the network has full connectivity by choosing a PC and pinging other devices on the network. Part 1: Plan an ACL Implementation Step 1: Investigate the current network configuration.īefore applying any ACLs to a network, it is important to confirm that you have full connectivity. The routers are already configured, including IP addresses and Enhanced Interior Gateway Routing Protocol (EIGRP) routing.
![standard access acl packet tracer activity 1 standard access acl packet tracer activity 1](http://freeccnalab.com/wp-content/uploads/2013/06/EXT-ACL.jpg)
This activity focuses on defining filtering criteria, configuring standard ACLs, applying ACLs to router interfaces, and verifying and testing the ACL implementation. Standard access control lists (ACLs) are router configuration scripts that control whether a router permits or denies packets based on the source address. Part 2: Configure, Apply, and Verify a Standard ACL Background / Scenario 7.2.1.6 Packet Tracer Configuring Numbered Standard IPv4 ACLs Addressing Table Device